1. //
  2. Start
  3. //
  4. Publications
  5. //
  6. Browse
  7. //

Browse by research area

381 - 390 out of 1,674Page size: 10

  1. In situ studies of light metals with synchrotron radiation and neutrons

    Staron, P., Beckmann, F., Lippmann, T., Stark, A., Oehring, M., Pyczak, F., Salgado, M., Hort, N., Eckerlebe, H., Kainer, K. U., Müller, M. & Schreyer, A., 06.2011, Light Metals Technology V. Dieringa, H., Hort, N. & Kainer, K. U. (eds.). Trans Tech Publications Ltd, p. 192-197 6 p. (Materials Science Forum; vol. 690).

    Research output: Contributions to collected editions/works › Article in conference proceedings › Research › peer-review

  2. Magnesium permanent mold Castings optimization

    Elsayed, F. R., Hort, N., Salgado-Ordorica, M. A. & Kainer, K., 06.2011, Light Metals Technology V. Dieringa, H., Hort, N. & Kainer, K. U. (eds.). Trans Tech Publications Ltd, p. 65-68 4 p. (Materials Science Forum; vol. 690).

    Research output: Contributions to collected editions/works › Article in conference proceedings › Research › peer-review

  3. Modeling Bolt Load Retention of Ca modified AS41 using compliance-creep method

    Anopuo, O., Huang, Y., Hort, N., Kainer, K. U. & Maier, P., 06.2011, Light Metals Technology V. Dieringa, H., Hort, N. & Rainer, K. U. (eds.). Trans Tech Publications Ltd, p. 278-281 4 p. (Materials Science Forum; vol. 690).

    Research output: Contributions to collected editions/works › Article in conference proceedings › Research › peer-review

  4. Improved cytotoxicity testing of magnesium materials

    Fischer, J., Pröfrock, D., Hort, N., Willumeit, R. & Feyerabend, F., 25.06.2011, In: Materials Science and Engineering: B. 176, 11, p. 830-834 5 p.

    Research output: Journal contributions › Journal articles › Research › peer-review

  5. Published

    Geometrical Characterization of Polyethylene Oxide Nanofibers by Atom Force Microscope and Confocal Laser Scanning Microscope

    Fuhrhop, C. & Georgiadis, A., 30.06.2011, FiberMad 11, International Conference on Fibrous Products in Medical and Health Care . Talvenmaa, P. (ed.). Tampere University of Technology, 7 p.

    Research output: Contributions to collected editions/works › Article in conference proceedings › Research

  6. Influence of composition on hot tearing in binary mg-zn alloys

    Zhou, L., Huang, Y. D., Mao, P. L., Kainer, K. U., Liu, Z. & Hort, N., 08.2011, In: International Journal of Cast Metals Research. 24, 3-4, p. 170-176 7 p.

    Research output: Journal contributions › Journal articles › Research › peer-review

  7. The multipole resonance probe: Characterization of a prototype

    Lapke, M., Oberrath, J., Schulz, C., Storch, R., Styrnoll, T., Zietz, C., Awakowicz, P., Brinkmann, R. P., Musch, T., Mussenbrock, T. & Rolfes, I., 08.2011, In: Plasma Sources Science and Technology. 20, 4, 4 p., 042001.

    Research output: Journal contributions › Comments / Debate / Reports › Research

  8. Compressive strength and hot deformation behavior of TX32 magnesium alloy with 0.4% Al and 0.4% Si additions

    Rao, K. P., Prasad, Y. V. R. K., Dharmendra, C., Hort, N. & Kainer, K. U., 25.08.2011, In: Materials Science and Engineering A. 528, 22-23, p. 6964-6970 7 p.

    Research output: Journal contributions › Journal articles › Research › peer-review

  9. Published

    Automatisierung eines ToF-Messstands

    Werner, S., Georgiadis, A., Papadoudis, J. & Lippelt, S., 09.2011, Virtuelle Instrumente in der Praxis 2011: Messtechnik, Automatisierung ; Begleitband zum 16. VIP-Kongress. Jamal, R. & Heinze, R. (eds.). VDE Verlag GmbH, p. 25 - 29 3 p.

    Research output: Contributions to collected editions/works › Article in conference proceedings › Research › peer-review

  10. Published

    Force measuring module for use in e.g. crutch for measurement of active force at patient lower arm during use of walking support in rehabilitation phase after e.g. leg injury, has transmission device transmitting value to evaluation device

    Schimmack, M. & R., S., 06.09.2011, IPC No. A61H3/02; G01L1/00; G01L1/16; G08C17/02, MünchenVerlag, Patent No. DE102009057424, 12.08.2009

    Research output: Patents › Patent

Previous 1...35 36 37 38 39 40 41 42 ...168 Next