Development of high performance single-phase solid solution magnesium alloy at low temperature

Publikation: Beiträge in ZeitschriftenZeitschriftenaufsätzeForschungbegutachtet

Authors

Magnesium (Mg) alloys are well known as potential candidates for engineering structural materials due to their low density and high specific strength. However, compared with traditional steel or aluminum materials, Mg alloys have not been widely used. Up to now, these present commercial products are mainly fabricated by cast. In contrast to cast products, wrought Mg alloys only have a market share of less than 5%. [a ] Most of the barriers preventing wrought produces from widespread applications arising from low ductility/toughness and poor corrosion. [b ] Therefore, to improve the formability and corrosion resistance becomes an urgent problem to extend the applications of deformed Mg materials. As-cast Mg-RE based single solid solution alloy has grain size of 55 μm. The elongation is higher than 30% at room temperature. The alloy exhibits obviously ductile characterization on the fracture surface, which can be regarded as a new high performance deformed materials or biomaterials.

OriginalspracheEnglisch
ZeitschriftAdvanced Engineering Materials
Jahrgang14
Ausgabenummer3
Seiten (von - bis)178-184
Anzahl der Seiten7
ISSN1438-1656
DOIs
PublikationsstatusErschienen - 03.2012
Extern publiziertJa

DOI

Zuletzt angesehen

Publikationen

  1. Passive Rotation Compensation in Parallel Kinematics Using Quaternions
  2. The Mobile Phone: From an Instrument of Microcoordination to a Universal Control Device
  3. Hot forging of cast magnesium alloy TX31 using semi-closed die and its finite element simulation
  4. Forging of Mg–3Sn–2Ca–0.4Al Alloy Assisted by Its Processing Map and Validation Through Analytical Modeling
  5. CHANGING RECREATIONAL ACTIVITIES FOR REDUCING INSOMNIA SEVERITY? RESULTS FROM A SERIAL MEDIATION ANALYSIS ON THE IMPACT OF RECREATIONAL BEHAVIOR AS A MECHANISM OF CHANGE IN DIGITAL INTERVENTIONS FOR INSOMNIA
  6. Effect of yttrium addition on lattice parameter, Young's modulus and vacancy of magnesium
  7. Forging of cast Mg-3Sn-2Ca-0.4Al-0.4Si magnesium alloy using processing map
  8. As cast microstructures on the mechanical and corrosion behaviour of ZK40 modified with Gd and Nd additions
  9. Influence of Dy in solid solution on the degradation behavior of binary Mg-Dy alloys in cell culture medium
  10. Effect of erbium modification on the microstructure, mechanical and corrosion characteristics of binary Mg-Al alloys
  11. Effect of grain size and structure, solid solution elements, precipitates and twinning on nanohardness of Mg-Re alloys
  12. Acceleration as process
  13. Wavlet analysis for rotor fault diagnosis with rub-impact of rotor systems
  14. Microstructural and Mechanical Aspects of Reinforcement Welds for Lightweight Components Produced by Friction Hydro Pillar Processing
  15. Mechanical properties and microstructures of nano SiC reinforced ZE10 composites prepared with ultrasonic vibration
  16. Comparative study on corrosion behavior of we33 in immersion and polarization influenced by heat treatment
  17. Study of the solidification of AS alloys combining in situ synchrotron diffraction and differential scanning calorimetry
  18. Effect of internal defects on tensile properties of A356 casting alloys
  19. Empirical research on mathematical modelling
  20. Microstructure evolution of Mg-11Gd-4.5Y-1Nd-1.5Zn-0.5Zr (wt%) alloy during deformation and its effect on strengthening