Materials Science and Engineering A, ‎0921-5093

Journal

  1. 2016
  2. Microstructure evolution of Mg-11Gd-4.5Y-1Nd-1.5Zn-0.5Zr (wt%) alloy during deformation and its effect on strengthening

    Yu, Z., Huang, Y., Gan, W., Mendis, C. L., Zhong, Z., Brokmeier, H. G., Hort, N. & Meng, J., 07.03.2016, In: Materials Science and Engineering A. 657, p. 259-268 10 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  3. In situ synchrotron radiation diffraction investigation of the compression behaviour at 350 °C of ZK40 alloys with addition of CaO and Y

    Buzolin, R. H., Mendis, C. L., Tolnai, D., Stark, A., Schell, N., Pinto, H., Kainer, K. U. & Hort, N., 10.05.2016, In: Materials Science and Engineering A. 664, p. 2-9 8 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  4. 2017
  5. As cast microstructures on the mechanical and corrosion behaviour of ZK40 modified with Gd and Nd additions

    Buzolin, R. H., Mohedano, M., Mendis, C. L., Mingo, B., Tolnai, D., Blawert, C., Kainer, K. U., Pinto, H. & Hort, N., 13.01.2017, In: Materials Science and Engineering A. 682, p. 238-247 10 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  6. 2019
  7. Published

    Mechanical characterization of as-cast AA7075/6060 and CuSn6/Cu99.5 compounds using an experimental and numerical push-out test

    Greß, T., Stahl, J., Mittler, T., Spano, L., Chen, H., Ben Khalifa, N. & Volk, W., 28.03.2019, In: Materials Science & Engineering A. 751, p. 214-225 12 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  8. Microscopic deformation compatibility during biaxial tension in AZ31 Mg alloy rolled sheet at room temperature

    Xia, D., Huang, G., Liu, S., Tang, A., Gavras, S., Huang, Y., Hort, N., Jiang, B. & Pan, F., 22.05.2019, In: Materials Science and Engineering A. 756, p. 1-10 10 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  9. Abnormal extrusion texture and reversed yield asymmetry in a Mg–Y-Sm-Zn-Zr alloy

    Lyu, S., Zheng, R., Xiao, W., Huang, Y., Gavras, S., Hort, N., Li, G. & Ma, C., 08.07.2019, In: Materials Science and Engineering A. 760, p. 426-430 5 p.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  10. 2020
  11. Published

    Microstructure by design: An approach of grain refinement and isotropy improvement in multi-layer wire-based laser metal deposition

    Froend, M., Ventzke, V., Dorn, F., Kashaev, N., Klusemann, B. & Enz, J., 20.01.2020, In: Materials Science and Engineering A. 772, 13 p., 138635.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  12. In situ compressive investigations on the effects of solid solution Gd on the texture and lattice strain evolution of Mg

    Xu, Y., Huang, Y., Zhong, Z., You, S., Gan, W., Xiao, B., Maawad, E., Schell, N., Gensch, F., Pan, F. & Hort, N., 13.02.2020, In: Materials Science and Engineering A. 774, 138938.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  13. Effect of biaxial compressive stress state on the microstructure evolution and deformation compatibility of rolled sheet Mg alloy AZ31 at room temperature

    Xia, D., Zhang, J., Chen, X., Huang, G., Jiang, B., Tang, A., Gavras, S., Huang, Y., Hort, N. & Pan, F., 03.07.2020, In: Materials Science and Engineering A. 789, 139599.

    Research output: Journal contributionsJournal articlesResearchpeer-review

  14. Achieving enhanced mechanical properties in Mg-Gd-Y-Zn-Mn alloy by altering dynamic recrystallization behavior via pre-ageing treatment

    Wang, K., Dou, X., Wang, J., Huang, Y., Gavras, S., Hort, N., Liu, S., Hu, H., Wang, J. & Pan, F., 14.07.2020, In: Materials Science and Engineering A. 790, 139635.

    Research output: Journal contributionsJournal articlesResearchpeer-review

Recently viewed

Publications

  1. Consequence evaluations and moral concerns about climate change
  2. Planning for Sea Spaces I: Processes, Practices and Future Perspectives
  3. Broad values as the basis for understanding deliberation about protected area management
  4. Article 66 CISG
  5. Power centres
  6. Mental models and attentional processes in car driving
  7. Technik – Magie – Medium
  8. Investigation of the deformation behavior of Fe-3%Si sheet metal with large grains via crystal plasticity and finite-element modeling
  9. Variational Pragmatics and World Englishes
  10. Success factors in Balanced Scorecard implementations
  11. The disproportionate value of scattered trees
  12. Working hour arrangements and working hours
  13. Understanding Similarities and Differences of Digital Health Platforms
  14. Germany Humboldt University in Berlin: Its Transformation in the Process of German Unification
  15. Comparison of Panel Cointegration Tests
  16. Revegetation in agricultural areas: the development of structural complexity and floristic diversity
  17. Digitale Transformation, quo vadis?
  18. Propagating Maximum Capacities for Recommendation
  19. Analysis of brittle layer forming mechanism in Ti6Al4V sloping structures by SLM technology
  20. Lagrangian analysis of long-term dynamics of turbulent superstructures
  21. Foreign and Domestic Takeovers in Germany: First Comparative Evidence on the Post-acquisition Target Performance using new Data
  22. Digitized Evaluation of Academic Opportunities to Learn (OTLs) Concerning Linguistically Responsive Teaching (LRT)
  23. Introduction
  24. A classification of teacher interventions in mathematics teaching
  25. Analysing money demand relation for OECD countries using common factors
  26. Editorial
  27. Notting Hill Gate 3 Basic
  28. Low Resource Question Answering: An Amharic Benchmarking Dataset
  29. BAuA-Arbeitszeitbefragung: Vergleich 2015 – 2017 – 2019
  30. Increasing the accuracy and efficiency of wildlife census with unmanned aerial vehicles
  31. Inquiry-based Learning Environments to Welcome the Diversity of a Chemistry Class
  32. Team Emotions and Team Learning